HP Storage Mirroring V5 Software - Manual (Page 173)

19 - 27
Kernel ActFailCount The number of activation code failures when loading the source or target.
Activation codes can be bad for reasons such as: expiration of evaluation codes,
duplicate codes, incorrect codes, etc.
TargetOpen
Handles The number of handles currently open on the target
DriverQueue
Percent The amount of throttling calculated as a percentage of the stop replicating limit
Target PeerAddress The IP address of the source machine
Local Address The IP address of the target machine.
Ops Received The total number of operations received by this machine as a target since the
Storage Mirroring service was loaded
Mirror Ops
Received The total number of mirror operations received by this machine as a target since
the Storage Mirroring service was loaded. This number does not reset to zero for
remirrors.
Retries The number of retries performed before all operations were completed
OpsDropped The number of operations skipped during a difference mirror. During a difference
mirror, if Storage Mirroring detects that there have been no changes to a file, then it
will indicate the number of operations it did not send for this file in this field.
Ops Remaining The total number of operations that are left in the target queue
Orphan Files
Removed The number of orphan files removed from the target machine
Orphan
Directories
Removed The number of orphan directories removed from the target machine
Orphan Bytes
Removed The number of orphan bytes removed from the target machine
Bytes In Target
Queue The number of bytes currently in the system memory queue on the target
Bytes In Target
Disk Queue The number of bytes currently in the disk queue on the target
Tasks
Succeeded The number of task commands that have succeeded on the target
TasksFailed The number of task commands that have failed on the target
TasksIgnored The number of task commands that have been ignored on the target
Source auto
DisConnects The number of automatic disconnects since starting Storage Mirroring.
Auto-disconnects occur because the source no longer sees the target This could be
because the connection between the two has failed at some point or because the
target machine data is changing on the source faster than the source can get the
data to the target. This field tracks the number of times an auto-disconnect has
occurred since the Storage Mirroring service was started.
autoRe
Connects The number of automatic reconnects since starting Storage Mirroring.
Auto-reconnect occurs after a target machine is back online. This field tracks the
number of times an auto-reconnect has happened since the Storage Mirroring
service was started.
lastFileTouched The last filename that had a replication operation executed
Connection conPeer
Address The IP address of the target machine
connectTime The time that this connection was established
Category Statistic Description