HP Storage Mirroring V5 Software - Manual (Page 159)

19 - 13
4044 Service Error An error was encountered and
replication has been stopped. It is
necessary to stop and restart the
service to correct this error. Contact technical support if this error
persists.
4045 Service Error %1 value must be between 1025 and
65535. Using default of %2. Verify that the Storage Mirroring port
value you are trying to use is within the
valid range. If it is not, it will
automatically be reset to the default
value.
4046 Service Error This service failed to start because of a
possible port conflict. Win32 error: %1 Verify that the Storage Mirroring ports
are not conflicting with ports used by
other applications.
4047 Service Error Could not load ZLIB DLL %1. Some
levels of compression will not be
available. The compression levels available
depend on your operating system. You
can reinstall the software, using the
installation Repair option, to install a
new copy of the DynaZip.dll, or
contact technical support if this error
persists.
4048 Service Info. Service has started a delete orphans
task to %1 (%2) for Replication Set %3,
ID: %4 No action required.
4049 Service Info. Service has paused a delete orphans
task to %1 (%2) for Replication Set %3,
ID: %4 No action required.
4050 Service Info. Service has resumed a delete orphans
task to %1 (%2) for Replication Set %3,
ID: %4 No action required.
4051 Service Info. Service has stopped a delete orphans
task to %1 (%2) for Replication Set %3,
ID: %4 No action required.
4052 Service Info. Service has completed a delete
orphans task to %1 (%2) for
Replication Set %3, ID: %4 No action required.
4053 Service Info. Service has started a restore task to
%1 (%2) for Replication Set %3, ID: %4 No action required.
4054 Service Info. Service has paused a restore task to %1
(%2) for Replication Set %3, ID: %4 No action required.
4055 Service Info. Service has resumed a restore task to
%1 (%2) for Replication Set %3, ID: %4 No action required.
4056 Service Info. Service has stopped a restore task to
%1 (%2) for Replication Set %3, ID: %4 No action required.
4057 Service Info. Service has completed a restore task
to %1 (%2) for Replication Set %3, ID:
%4 No action required.
4058 Service Info. Service has started a verification task
to %1 (%2) for Replication Set %3, ID:
%4 No action required.
4059 Service Info. Service has paused a verification task to
%1 (%2) for Replication Set %3, ID: %4 No action required.
4060 Service Info. Service has resumed a verification task
to %1 (%2) for Replication Set %3, ID:
%4 No action required.
ID Category Severity Event Message Required Response