HP Storage Mirroring V5 Software - Manual (Page 171)

19 - 25
Running DTStat from the command prompt
From a command prompt, use the DTStat command from the location where Storage Mirroring is installed.
Command DTSTAT
Description Starts the DTStats statistics logging utility from a command prompt.
Syntax DTSTAT [-p][-i < interval >][-t < filename >] [-f < filename >][-s < filename >]
[-st < filename >][-IP < address >][-START < mm/dd/yyyy hh:mm >][-STOP < mm/dd/yyyy hh:mm >]
[-SERVER < ip_address > < port_number >]
Options ‹
-p —Do not print the output to the screen
‹ -i interval —Refresh from shared memory every interval seconds
‹ -t filename —Save the data from memory to the specified binary file filename
‹
-f filename —Reads from a previously saved binary file, filename , that was generated using the -t
option instead of reading from memory
‹
-s filename —Saves only the connection data from the data in memory to an ASCII,
comma-delimited file, filename
‹
-st filename —Saves only the target data from the data in memory to an ASCII, comma-delimited
file, filename
‹
-f filename1 -s filename2 —Saves only the connection data from a previously saved binary file,
filename1 , to an ASCII, comma-delimited file, filename2
‹
-f filename1 -st filename2 —Saves only the target data from a previously saved binary file,
filename1 , to an ASCII, comma-delimited file, filename2
‹
-IP address —Filters out the specified address in the IP address field and prints only those entries.
Specify more than one IP address by separating them by a comma.
‹ - START mm/dd/yyyy hh:mm —Filters out any data prior to the specified date and time
‹ - STOP mm/dd/yyyy hh:mm —Filters out any data after the specified date and time
‹ SERVER ip_address port_number —Connects DTStat to the specified IP address using the
specified port number instead of to the local machine
Examples ‹ DTStat -i 300
‹ DTStat -p -i 300 -t AlphaStats.sts
‹
DTStat -f AlphaStats.sts -s AlphaStats.csv -start 02/02/2007 09:25
‹ DTStat -server 206.31.4.51 1106
Notes ‹ This command is not case-sensitive.
‹ If no options are specified, DTStat will print the output to the screen at an interval of every one
second.
‹ If the statistics are not changing, DTStat will discontinue writing until statistics begin updating
again.