HP StoreAll Storage - Manual (Page 43)

Example 31 Get the firmware update recommendation for the specified set of components
# hpsp_fmt -fr -c ilo3,oa,enclosure_io_mod,nic,storage_ctlr
Enter OA Username:Administrator
Enter OA Password:
Based on the configuration, Flash recommendation may take 19 minutes.
<<< Completed >>>
Updating firmware
Syntax
The complete syntax for the firmware update command is:
# hpsp_fmt --flash [--force]
{[,…]|--deviceid ]}>
[--ignorerole] [--reboot] [--scriptmode] [--oaip ]
[--credservice]|{[--oauser ] [--oapasswd ] [--vcuser
] [--vcpasswd ]}
You can also replace --flash with -f.
Description
Update the firmware for all components, a component category, a single component, or a set of
components:
•
To update a single component:
# hpsp_fmt –f –c
•
To update a set of components:
# hpsp_fmt –f –c [,component name]…
•
To update all components of a category:
# hpsp_fmt –f
If the flash recommendation for a component is NONE or DOWNGRADE, executing the --flash
subcommand without any options does not perform a firmware update because the component’s
active firmware is either up-to-date (for NONE) or is newer than the tool-qualified version (for
DOWNGRADE). In these cases, you can use the --force option to force the firmware update or
downgrade of the component to the qualified firmware version. You can only use the --force
option when updating the firmware of a single component. The --force option cannot be used
when updating a set of components or a category of components.
Updating firmware 43