HP StoreAll Storage - Manual (Page 17)

Command options
Table 23 (page 17) lists the hpsp_fmt command options that can be used on the StoreAll platforms.
Table 23 Command Options
9320 9300 9730 X9720 8800 8200 Option
✓ NA NA NA NA NA -ci, or --ctrlip
✓ NA NA NA NA NA -cu, or --ctrluser
✓ NA NA NA NA NA -cp, or --ctrlpasswd
✓ ✓ ✓ ✓ NA NA -cs, or --credservice
✓ ✓ ✓ ✓ ✓ ✓ -F, or --format
✓ ✓ ✓ ✓ ✓ ✓ -fo, or --force
✓ ✓ ✓ ✓ ✓ ✓ -o, or --outputfile
✓ ✓ ✓ ✓ ✓ ✓ -r, or --reboot
✓ ✓ ✓ ✓ ✓ ✓ -s, or --scriptmode
✓ ✓ ✓ ✓ ✓ ✓ -v, or --verbose
NA NA ✓ ✓ NA NA -i, or --ignorerole
NA NA ✓ NA NA NA -ic, or --ignorediskdualpathcheck
NA NA ✓ ✓ NA NA -id, or --deviceid
NA NA ✓ ✓ NA NA -oi, or --oaip
NA NA ✓ ✓ NA NA -op, or --oapasswd
NA NA ✓ ✓ NA NA -ou, or --oauser
NA NA ✓ ✓ NA NA -vu, or --vcuser
Command option descriptions
The descriptions in Table 24 (page 17) explain the results of using the corresponding command
option.
Table 24 Command option descriptions
Description Option
The storage controller's IP address. -ci, or --ctrlip
The use name of the storage controller given by the --ctrlip option. The
user should have administrative/write privileges for the flash operation. -cu, or --ctrluser
Read-only privileges are sufficient for the discovery and flash recommendation
operation.
The password for the user account given by the --ctrluser option for the
storage controller given by the --ctrlip option. -cp, or --ctrlpasswd
Credential service. Use the credential service to obtain the user credentials for
the storage controller/Onboard Administrator/Virtual Connect. In 9320 and -cs, or --credservice
9300 configurations, for the active FW version discovery and the flash
recommendation operation, this tool automatically fetches each configured
storage controller IP and its user credentials.
For the flash operation, you must provide this option along with the --ctrlip
option. In this case, the command fetches the user credentials for the given
controller IP address.
Command options 17