HP 3000 Enterprise Virtual Array - Manual (Page 98)

Figure 43 Installing a blower
Removing a power supply
CAUTION:
When a power supply is removed, the enclosure could shut down within seven minutes due to overheating
unless the power supply is replaced.
1. Disengage the power cord lock (1, Figure 44 ) and disconnect the power cord from the power supply.
CAUTION:
When removing the left power supply, ensure the cord lock on the right power supply is
engaged. This will avoid inadvertently disconnecting the right power supply. Also take care
to avoid disrupting the cables on the I/O module to left of the power supply.
2. Lift up on the wine-colored mounting latch (2), then grasp the blower (3) and pull the power supply
out of the enclosure.
3. Remove the blower from the defective power supply and install it on the replacement power supply.
Figure 44 Removing a power supply
Installing a power supply
1. Lift up on the module latch (1, Figure 45 ) and slide the power supply into the enclosure until it is
fully seated.
98 Customer replaceable units