Removing a disk, Changing the device addition policy, Checking disk group status – HP 3000 Enterprise Virtual Array User Manual
Page 93: Figure 37
Figure 37 Checking disk group status
Removing a disk
CAUTION:
Rotating media can make the disk difficult to handle. To avoid dropping and damaging the disk, wait
approximately 30 seconds for the media to stop rotating before removing the disk from the enclosure.
1.
Push in the wine-colored ejector button (1) and pull the release lever (2) down to the full open
position.
2.
Pull the disk part way out of the enclosure (3) and wait for the media to stop spinning.
3.
When the media has stopped spinning, remove the disk from the enclosure.
1
1
0115a
2
3
Figure 38 Removing a disk
Changing the Device Addition Policy
To prevent the storage system from automatically grouping a new disk that may have the incorrect
firmware on it, check the Device Addition Policy and set it to manual if necessary:
1.
In the HP Command View EVA Navigation pane, select the storage system.
The Initialized Storage System Properties window opens.
2.
Click System Options.
3.
Select Set system operational policies.
4.
If the Device Addition Policy is set to Automatic, change it to Manual.
5.
Click Save changes.
HP StorageWorks 3000/5000 Enterprise Virtual Array user guide (VCS 4.xxx)
93