Disk drive status indicators, Disk drive status displays, Disk drive status indicator descriptions – HP 3000 Enterprise Virtual Array User Manual
Page 50
•
Both online high-performance disk drives and FATA disk drives in a variety of capacities and
spindle speeds.
•
Better vibration damping for improved performance.
Up to 14 disk drives can be installed in a drive enclosure.
Disk drive status indicators
Three status indicators display the drive operational status.
shows the disk drive status
indicators.
provides a description of each status indicator.
Figure 15 Disk drive status indicators
1. Activity
2. Online
3. Fault
Table 9 Disk drive status indicator descriptions
Status indicator
Description
Activity
This green status indicator flashes when the disk drive is
being accessed. It is on when the drive is idle.
Online
The green status indicator is on when the disk drive is
online and operating normally. This indicator will be off
in the following situations:
•
There is no controller on the bus.
•
+5.1 VDC is not available.
•
The drive is not properly installed in the enclosure.
Fault
This amber status indicator is on when there is a disk drive
failure. Depending on the host controller, this indicator may
flash when the controller detects an error condition.
The amber status indicator flashes in synchronization with
the other two status indicators in response to the EMU
locate command.
Disk drive status displays
The disk drive status indicators can assume three states: on, off, or flashing. The status indicators states
for operational drive status are shown in
. See
for the non-operational drive status
indicator states.
50
Enterprise Virtual Array hardware components