Error reporting – HP XP P9500 Storage User Manual
Page 124
Table 62 Syntax requirements for optional parameters (continued)
Syntax requirements
Parameter
The equal sign is described between the right side and the parameter identification
name.
Specifying the right side is correct.
The parameter identification name is described immediately after the macro.
The parameters for the identification names are delimited by a comma (,).
An illegal phrase is not included in any statement.
Check that the number of phrases matches.
StartHrcPair
Check that the (If) has a matching (EndIf).
Entire check
Check that the last line in the execution statement terminates at (END).
Error reporting
The scripting error codes are slightly different than the general error codes.
shows the format of the scripting error codes.
describes the scripting error
messages.
lists the scripting error codes. In
the message
ID is the four-digit number displayed on the error message. The internal code is the four-digit number
displayed in the fifth column of the error trace file.
Figure 20 Scripting error code format
Table 63 Error messages
Corrective action
Conditions to verify
Message
Use the scripting error code to determine which
line contains the syntax error (see
), and fix the syntax error.
The syntax validity of the script is checked at the
start of execution. An error message will be
displayed if failed.
Syntax error
Use the scripting error code to determine which
line contains the parameter error (see
), and fix the parameter error.
The parameter validity of the script is checked
on executing each instruction. An error message
will be displayed if failed.
Parameter error
If you want to terminate the script or display a
message of error occurrence and indication
following steps, check that _Result is not 0 in script.
The result of the execution is checked on each
target device. If failed, the last error status is
displayed and error flag is set in the reserved
Rejection
variable _Result. Also script continues to be
executed.
If you want to terminate the script or display a
message of error occurrence and indication
following steps, check that _Result is not 0 in script.
The condition of each target device is checked
to be executable status. For example, the M-VOL
status must be simplex to create a pair. If failed,
Skip if not
executable
error flag is set in the reserved variable _Result.
Also script continues to be executed.
124
Continuous Access Synchronous Z scripting