HP Integrity NonStop H-Series - Manual (Page 85)

N1525A ACL Installation and User’s Guide — 527339-003
6 -1
6
Maintaining the Tape Drive
This section includes:
The only required maintenance task is to periodically run or replace the cleaning
cartridge. You can run user diagnostics from the Demo menu to check the
operation of the tape drive. Occasionally, HP issues new firmware upgrades that
must be performed by qualified service personnel.
Cleaning the Tape Drive
To run a cleaning cartridge, issue a command to run the cartridge from the
control panel, or select the Auto Clean mode on the Configure menu, described
in
Installing and Configuring the Tape Drive . The procedures that follow describe
how to install a cleaning cartridge, how to clean a tape drive using front panel
controls, and how to remove the cleaning cartridge.
Installing the Cleaning Cartridge
If you run the cleaning cartridge manually only, there are no restrictions on the
location of the cleaning cartridge. However, if the Auto Clean option you use
must reserve one or more slots in the magazine by using the Reserved Slots
option described in
Installing and Configuring the Tape Drive . On line 4 of the
Maintenance menu shown in Figure 6-3 , cleaning Slot 1 appears instead of Slot
11. If slots have been reserved, cleaning slot 1 is the first reserved slot in the
tape magazine.
Installing
To install the cleaning cartridge:
1. Examine the Default screen on the Control Panel to determine whether a
tape cartridge is loaded in the drive. If so, unload it as described in Section
3.
2. Remove the tape magazine from the tape drive using the procedure
described in Inserting and Removing Tape Cartridges on page 3-28.
3. Remove any tape cartridge present in Slot 1 (the slot nearest to the handle),
or in cleaning Slot 1 (the first reserved slot in the magazine).
4. Insert the cleaning cartridge in the slot emptied in Step 3.
Cleaning the Tape Drive 6-1
Installing the Cleaning Cartridge 6-1
Running From the Front Panel 6-2
Removing the Cleaning Cartridge 6-5