HP Integrity NonStop H-Series - Manual (Page 125)

Error Recovery Procedures and Fault Symptom
Codes
N1525A ACL Installation and User’s Guide — 527339-003
C -13
Intermodule Error Codes
6015 Ack Timeout - Out The Master intermodule process attempted to
initiate a packet transmission to a Slave
intermodule process, but a timeout occurred
waiting for the Slave's acknowledge. A, B, 1
6016 Ack Timeout - In The Master intermodule process attempted to
initiate a packet transmission from a Slave
intermodule process, but a timeout occurred
waiting for the Slave's acknowledge. A, B, 1
6017 Ack Invalid - Out The Master intermodule process attempted to
initiate a packet transmission to a Slave
intermodule process, but the Slave's acknowledge
was invalid. A, B, 1
6018 Ack Invalid - In The Master intermodule process attempted to
initiate a packet transmission from a Slave
intermodule process, but the Slave's acknowledge
was invalid. A, B, 1
6019 Comm Port Ack Error The Master intermodule process, after sending a
control byte to a Slave, was waiting for an
acknowledge, but the UART detected an error
condition. A, B, 1
6020 Command Overlap The Master intermodule process received a
Command from the Master control process, but a
previously issued command is still being
executed. A, B, 1
6021 Slave RTS Still Set The Master intermodule process has received a
valid acknowledge from a Slave, but the Slave's
RTSi line has remained asserted. A, B, 1
6022 Slave Addr Invalid The Master intermodule process received a
CommBlock from the Master control process, but
the specified Slave address exceeds the
maximum valid range. A, B, 1
6023 Slave Req Unknown The Master intermodule process detected an
active SRVREQ line, but, after sequencing
through all slave addresses, determined that no
Slave had its RTSi line asserted. A, B, 1
6024 Slave Has No Pkts The Master intermodule process is requesting the
Slave to send a packet, but the Slave has no
packets to send. A, B, 1
6025 Pkt ID Invalid A, B, 1
6026 No Slaves to Flash D, 1
6027 Master Has No Flash D, 1
6028 Slave Unavailable D, 1
6029 Slave Has No Flash D, 1
6030 Slave Dev. Incompat. D, 1
FSC Message Description ERP