HP Integrity NonStop H-Series - Manual (Page 26)

Installing and Configuring the Tape Drive
N1525A ACL Installation and User’s Guide — 527339-003
2 -6
Setting the SCSI ID
5. The Library SCSI ID is set to 3. If the bus ID needs to be set to 5, check that
the cursor is next to line 1, and press the down button repeatedly until the
display scrolls, as shown in Figure 2-7 .
Figure 2-6. Set SCSI Menu
Note. In Figure 2-6 , the cursor is next to line 1, and line 2 is indented, indicating a two-tiered
menu. The scroll buttons work on two levels in this type of menu, which is typical of many
menus under Configure. First-level navigation: When you press the down button, the cursor
moves to line 3. Press the down button again to scroll down to Bus ID. If you press the up
button, the cursor moves back to line 1.
If you press Enter while the cursor is next to line 1 (or line 3), the scroll buttons operate on the
second level. As a result, the cursor moves next to line 2 (or line 4), and a down arrow appears
at the end of line 4, indicating a list of options that you can view by scrolling.