Depression on the leading edge is left, Margins are wide – Canon imagePROGRAF iPF6400S User Manual
Page 947
Cause
Corrective Action
In the Control Panel menu, Cutting Mode is set to Eject or Man-
ual.
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
Depression on the leading edge is left
Depression on the leading edge is left
Cause
Corrective Action
Keeping a roll in the printer for a long time with-
out printing on it may leave a depression on the
leading edge.
When printing quality is most important, we recommend setting TrimEdge Reload to On or
Automatic so that the paper edge is automatically cut before printing.
(See "Menu Structure.")
Margins are wide
Margins are wide
Cause
Corrective Action
Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
This operation is normal.
When Cutting Mode in the Control Panel menu was set
to Manual, you selected Do not perform in response to
the "Perform the detection of paper leading edge?"
message.
Set Cutting Mode to Manual again, and select Perform(recommend) when the
"Perform the detection of paper leading edge?" message is displayed.
Note that when you select Perform(recommend), if the paper is strongly curled,
the Printhead may rub against the leading edge of the paper when the printing
starts.
(See "Specifying the Cutting Method for Rolls.")
iPF6400S
Depression on the leading edge is left
Troubleshooting
Problems Regarding Paper
947