Canon imagePROGRAF iPF6400S User Manual
Page 638
Setting Item
Description, Instructions
Adjust
Printer
Feed Pri-
ority
Adj. Pri-
ority
Automatic
Specify exact paper feeding, if desired. Normally, select Auto-
matic. Choose Print Quality for attractive printing. Choosing
Print Quality also makes banding less noticeable. Choose
Print Length if you prefer to feed the paper an exact amount.
Print Quality
Print Length
Adj.
Quality
Auto(GenuinePpr)
Specify this mode with paper identified in the Paper Refer-
ence Guide. (See "Displaying the Paper Reference
Guide.")
The printer prints and reads a test pattern for automatic adjust-
ment of the feed amount. (See "Automatic Banding Adjust-
ment.")
Auto(OtherPaper)
Specify this mode with paper not in the Paper Reference
Guide. (See "Displaying the Paper Reference Guide.")
The printer prints and reads a test pattern for automatic adjust-
ment of the feed amount. Note that this function takes more
time and consumes more ink than Auto(GenuinePpr). (See
"Automatic Banding Adjustment.")
Manual
Use this mode with highly transparent media or other paper for
which Auto(GenuinePpr) or Auto(OtherPaper) cannot be
used.
Print a test pattern for adjustment of the feed amount based on
the type of paper. (See "Manual Banding Adjust-
ment.")
Adjust
Length
Adjust-
ment-
Print
A:High
Print a test pattern for particular types of paper to compensate
for paper stretching or shrinkage, after which you enter the
amount of adjustment. (See "Adjusting Line
Length.")
B:Standard/Draft
Change
Settings
A:High
Displayed when you have selected Feed Priority > Adj. Prior-
ity > Print Length.
Adjustment relative to the amount of stretching or shrinkage of
the current paper.
Enter either the adjustment results from AdjustmentPrint or
the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends to
shrink, decrease the feed amount by choosing a lower adjust-
ment value. (See "Adjusting Line Length.")
B:Standard/Draft
Adj Far Ed Feed
Choose Yes to adjust the feed amount for the trailing edge.
Calibra-
tion
AutoAdjst(HiPrc) (*2)
Perform color calibration using the optional Spectrophotometer
Unit.
A test pattern for color calibration is printed and the adjustment
values are set automatically.
(See "Color Calibration Using the Spectrophotometer Unit (op-
tion).")
Auto Adjust
Execute color calibration using the printer sensor.
A test pattern for color calibration is printed and the adjustment
values are set automatically.
(See "Color Calibration Using the Printer Sensor.")
ColorCheck Print (*2)
Perform a printer color check using the optional Spectropho-
tometer Unit.
Color check is a function that prints and automatically meas-
ures the colors of a test pattern, and calculates the color differ-
ence from a calibration target (standard color values registered
in the printer).
(See "Color Checks Using the Spectrophotometer Unit (op-
tion).")
Menu Settings
iPF6400S
Control Panel
Printer Menu
638