Canon PowerShot SX600 HS - Manual (Page 10)

10
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode / Hybrid
Auto Mode
Other Shooting
Modes
P Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
Initial Preparations
Prepare for shooting as follows.
Attaching the Strap
z z Thread the end of the strap through the
strap hole ( ), and then pull the other
end of the strap through the loop on the
threaded end ( ).
Holding the Camera
z z Place the strap around your wrist.
z z When shooting, keep your arms close to
your body and hold the camera securely
to prevent it from moving. If you have
raised the flash, do not rest your fingers
on it.
Charging the Battery Pack
Before use, charge the battery pack with the included charger. Be sure to
charge the battery pack initially, because the camera is not sold with the
battery pack charged.
1 Insert the battery pack.
z z After aligning the  marks on the battery
pack and charger, insert the battery pack
by pushing it in ( ) and down ( ).
2 Charge the battery pack.
z z CB-2LY: Flip out the plug ( ) and plug
the charger into a power outlet ( ).
z z CB-2LYE: Plug the power cord into the
charger, then plug the other end into a
power outlet.
z z The charging lamp turns orange, and
charging begins.
z z When charging is finished, the lamp turns
green.
3 Remove the battery pack.
z z After unplugging the battery charger,
remove the battery pack by pushing it in
( ) and up ( ).
CB-2LYE
CB-2LY