PATLITE WDR-LE - Manual (Page 7)

5
Wireless Data Aquisition System Comprehensive User's Manual
Enforced
Before product mounting and wiring, be sure to turn the power source off .
Possible dange of electric shock is present.
Be sure the power source is in the proper operating voltage range.
Possible cause of fi re or failue may result.
Be sure to request the installation is to be accompanied by a professional contractor.
Possible cause of fi re, electric shock or falling may occur.
If an abnormal condition, such as smoke coming out in conjunction with a foul smell
occuring, immediately cut off the power source.
Possible cause of fi re, product failure or electric shock may occur under those conditions.
Prohibited
Do not use or store under the following cases:
• In a location with poor ventillation or such environment
• In a location which generates a strong electric or magnetic fi eld
• In a location exposed to direct sunlight
• In a location where impact or heavy vibration is present
• In a location exposed to heating appliances or direct heat
• In a location exposed to where dust or iron powder is present
• In a location exposed to extreme temperatures or high humidy
• In a location which the product may fall down
• In a location exposed to salty air
• In a location exposed to where explosive or corrosive gasses are present
Possible malfunction or failure may occur.
Do not drink or smoke near the product.
Liquid or tobacco ashes may cause failure to this product.
Do not use chemicals nearby.
Depending on the chemical, possibility of product disformation or discoloring may occur.
Enforced
Notice polarity of power source and properly connect the polarity.
Mistake in polarity may result in product failure.
Please
● Do not install this product near the vicinity of other electrical appliances.
Installation near Facsimiles, Computers, Televisions, Microwave Ovens or equipment using motors may cause
improper operation of this product.
● Operating under conditions indicated below where radio emission becomes narrower than the specifi cations may
cause the product's response to slow down.
・Steel doors or steel-enforced cement walls placed in between the transmitter and receiver.
・Mounting surface for the transmitter or reciver made of steel.
・Radio stations or strong radio waves in the vicinity
・High voltage lines or transmission lines in the vicinity.
● Please fully test in the customer's environment before installation.
:DUQLQJ
&DXWLRQ