PATLITE WDR-LE - Manual (Page 20)

18
Wireless Data Aquisition System Comprehensive User's Manual
5
Push the center screw straight through,then
tighten.
(Recommended Torque ：0.2 ∼ 0.3N･m)
Please
● Do not overtighten the Center Screw.
If overtightened, the possibility of internal damage
may occur.
6
▲ Align the marks (indicated on the inside of
the Top Cover) with the marks on the lens and
attach.
7
From procedure 6, attach the Special Adaptor
to the assembled Top Cover indicated above.
At this point, match the tab width of the Top Cover to
the guide width of the Bracket and attach.
Please
● Insert the cover until the tab snaps into place.
Please
● The white signal wire for the Signal Tower is used as the power source for the transmitter before factory shipment.
Please use the white signal wire as the power for the Signal Tower.（☞ pg. 73）
● The MAC Address is required for equipment identifi cation. Please record the MAC address number.
Center
Screw
Top Cover
Lens
Assembly
Tab
Width
Guide
Width