PATLITE WDR-LE - Manual (Page 53)

51
Wireless Data Aquisition System Comprehensive User's Manual
(3) Wireless Set Parameter Change Request
Use the "Wireless Set Paramer Change Request" to make wireless setting changes to the receiver
wireless module.
The contents of the setting will be shown after boot-up.（☞ 「8.4 Wireless ID Setting」）
SOP Cmd
Len Wireless Setting ID Wireless Setting ID Data FCS
0x02 0x00 0x12
1 byte 2 bytes 1 byte 2 bytes Unconditional 1 byte
① ②
① Wireless Setting ID ： 0x0210 ：Pan ID
0x0211 ：Frequency Channel
0x0230 ：Module Setting, Output Strength
0x0247 ：Group ID
② Wireless Setting ID Data ： Set Data for the Individual Wiring Setting ID.
(4) Wireless Set Parameter Change Received
The following is the received response from a "Wireless Set Parameter Change Received" request.
SOP Cmd Len
Status FCS
0x02 0x10 0x12 0x01
1 byte 2 bytes 1 byte 1 byte 1 byte
①
① Status ： 0x00 ：Pass
Any value outside the indication above is a "Fail" status.
(5) Wireless Set Parameter Acquisition Request Recieived
Use this request to acquisition the wireless settings from the receiver wireless module.
SOP Cmd Len
Wireless Setting ID FCS
0x02 0x00 0x13 0x02
1byte 2byte 1byte 2byte 1byte
①
① Wireless Setting ID ： 0x0210 ：PanID
0x0211 ：Frequency Channel
0x0230 ：Module Setting, Output Strength
0x0247 ：Group ID