NORD Drivesystems BU0040 - Manual (Page 43)

3 ControlBoxes – SK POT1-1
BU 0040 GB-0113 Subject to technical alterations 43
3 ControlBoxes
With the aid of ControlBoxes it is possible to control a frequency inverter with regard to speed and direction of
rotation.
3.1 SK SSX-3A
– Simple Setpoint Box
The "Simple Set Point Box" SK SSX-3A is a
compact control unit with a 4-digit, 7-segment
display, which is primarily intended for fixed
connection to the terminal bar of the frequency
inverter.
The control unit can be used as a handheld or
attached version (wall-mounted). A maximum cable
length of 20m must be observed.
Three operating modes are available, which are
automatically activated according to the connection
variant and the inverter series.
The entire range of functions can be used with the
SK 2xxE series.
If an RS 485 interface is available, the box can also
be used with SK 300E, SK 5xxE, SK 700E and
SK 750E inverters. However, in this case only the
485C mode (control mode via RS 485) is available.
3.1.1 Installation
The box can be opened by opening the screw
fastenings at the front. The connection terminals for the
electrical connections and a 2-part DIP switch element
are located inside the box on the rear side of the cover.
In addition to an M12 cable gland, the other section of
the housing contains 2 holes for optional wall mounting.
Mounting on an SK 2xxE frequency inverter
An adapter kit is available for the direct mounting of the
SK SSX-3A onto an SK 2xxE series frequency inverter.
Designation: SK TIE4-SSX-3A-adapter kit
Part No.: 275274910
Scope of
supply:
1x Mounting plate
1x M16 x1.5 cable gland
4x SW7-M4 spacer bolts
4x M4 x 8 countersink screw
2x M4 x 8 cylindrical-head screw
1x SK 200E connection cable SSX_3A
Illustration: Installation material, without connection
cable and cable gland.
Holes for wall
mounting