NORD Drivesystems BU0040 - Manual (Page 39)

2 Parameter Boxes – System parameters
BU 0040 GB-0113 Subject to technical alterations 39
Display
Error number
Fault
Text in the ParameterBox
Cause

Remedy
Identification errors
220 Unknown device Device ID not found.
The connected inverter is not listed in the database of the ParameterBox;
no communication can be established.

Please contact your Getriebebau Nord Representative.
221 Software version not recognised The software of the connected frequency inverter is not listed in the
ParameterBox database, no communication can be set up.

Please contact your Getriebebau Nord Representative.
222 Inverter extension level not recognised An unknown module has been detected in the frequency inverter (Customer
interface / Special extension).

Please check the modules installed in the frequency inverter

If necessary, check the software version of the ParameterBox
and the frequency inverter.
223 Bus configuration has changed After restoring the last Bus configuration, a device is reported that is
different from the one stored.
This error can only occur if the parameter >Auto. Bus Scan< is set to OFF
and another device has been connected to the ParameterBox.

Activate the automatic Bus scan function.
224 Device is not supported The inverter type entered in the ParameterBox is not supported!
The ParameterBox cannot be used with this frequency inverter.
225 The connection to the
inverter is blocked Access to a device that is not online (previous Time Out error).

Carry out a bus scan via the parameter >Bus Scan< (P1001).
ParameterBox operating error
226 Source and target are different
devices Copying objects of different types (from / to different inverters) is not
possible.
227 Source is empty Copying of data from a deleted (empty) storage medium
228 This combination is not permitted Target and source for the copying function are the same. The command
cannot be carried out.
229 Object selected is empty Parameterisation attempt of a deleted storage medium
230 Different software versions Warning
Copying objects with different software versions can lead to problems when
transferring parameters.
231 Invalid password Attempt to alter a parameter without a valid Box password being entered in
parameter >Box Password< P 1306.
232 Bus scan only during operation: online A bus scan (search for a connected frequency inverter) is only possible
when in ONLINE mode.