Thermo Fisher Scientific CyberScan pH 1100/pH 2100 - Manual (Page 9)

Instruction Manual pH 1100/ 2100
9
1.4 Electrode Holder
The electrode holder is included in the same box as the meter.
To attach the electrode holder to the meter:
1. The electrode holder base attached to the
bottom of the meter comes in the shipping
position. See Figure 3.
2. Use a Phillips screwdriver to remove the
screw holding the electrode holder in
shipping position. See Figure 3.
3. Slide the electrode base away from the
meter until the second screw slot lines up
with the original screw hole. Use the screw
removed earlier to secure electrode holder
base into position. See Figure 3.
4. The electrode holder arm is reversible. If
desired, remove screw holding electrode
holder base and slide base out of brackets.
Slide base into brackets on opposite side
and replace screw.
5. To install the electrode arm, turn meter back
to the upright position. See Figure 4.
6. Line up the hole on the base of the
electrode holder arm with the peg on the
electrode holder base. Slide the hole
securely onto the electrode holder base.
See Figure 4.
7. The electrode arm is now ready to swing
into desired position.
Figure 3: Bottom of Meter
Figure 4: Fix electrode holder arm to holder base