Thermo Fisher Scientific CyberScan pH 1100/pH 2100 - Manual (Page 29)

Instruction Manual pH 1100/ 2100
29
10.1.4 Meter general configuration setup submenus
Press SETUP to enter setup mode. Use >/CAL to select meter, and then press ENTER. Use the
∆/MI and ∇/MR keys to
scroll through submenus. There are 8 submenus (programs) in the meter setup mode:
Mem Clear Setup:P4.6
Press ENT. to Select
Meter Reset :P4.7
Press ENT. to Select
Date/Time Setup:P4.0
Press ENT. to Select
Backlight Setup:P4.1
Press ENT. to Select
Data Log Setup:P4.2
Press ENT. to Select
Data Transfer :P4.5
Press ENT. to Select
Date/Time Setup:P4.0
Backlight Setup:P4.1
Data Log Setup:P4.2
Memory R ecall Setup:P4.3
Rs232 C ommunication
Setup:P4.4
Data Transfer Setup:P4.5
Sets day, month, year, hour and
minute
-Turns backlight on or off and
selects amount of time
backlight stays on after button
press
-Sets automatic or manual
memory recall
-Selects automatic or manual
memory recall.
-Sets Baud Rate (4800, 9600 or
19200)
-Sets Stop Bit (One or Two)
-Sets Parity (None, Odd or
Even)
-Selects what data gets sent to
computer/printer w hen PRINT
and sets
datalogging time interval (10
seconds to 23 hours, 59
minutes, 59 seconds).
Memory C lear Setup:P4.6
Meter Reset:P4.7
Clears data from stored
memory
-Resets meter to factory
defaults
-Clears all pH/mV/Ion
calibration data
-Resets manual temperature
compensation to 25.0°C
-Resets pH/mV/Ion
measurement alarm to OFF
-Resets pH/mV/Ion
calibration due alarm to
OFF
-Resets stable indicator to
ON with low stability setting
-Resets datalogging and
memory recall to manual
-Resets backlight to ON with
2.0 minute duration
-Clears all data from stored
memory
-Resets baud rate to 9600
-Resets stop bit to 2
-Resets parity to EVEN
MemRecall Setup:P4.3
Press ENT. to Select
see page 50
see page 51
see page 52
see page 52
see page 53
see page 53
Tx/Rx Parameter: P4.4
Press ENT. to Select
see page 54
see page 54