KROHNE IFC 090 Converter EN - Manual (Page 22)

4/3
4.3 Function of keys
The cursor (flashing part of display) has a grey background in the following descriptions.
To start operator control
Measuring mode
1 3 . 5 7 1
m 3 / h r
→
Operator control mode
↵
PLEASE NOTE: When “YES” is set under Fct. 3.04 ENTRY CODE, “CodE 1 - - - - - - - - -”
appears in the display after pressing the
→
key.
The 9-keystroke Entry Code 1 must now be entered:
→ → → ↵ ↵ ↵ ↑ ↑ ↑
(each keystroke acknowledged by “ * ”).
To terminate operator control
Press key
↵
repeatedly until one of the following menus
Fct. 1.00 OPERATION, Fct. 2.00 TEST or Fct. 3.00 INSTALL. is displayed.
Press key
↵
Store new parameters: acknowledge by
pressing key
↵
. Measuring mode continued
with the new parameters.
New parameters not to be stored:
press key
↑
to display „STORE.NO“.
Measuring mode continued with the „old“
parameters after pressing key
↵
.
S T O R E Y E S
F c t . 1. 0 0
O P E R A T I O N
F c t . 3. 0 0
I N S T A L L.