KROHNE IFC 020 Converter EN - Manual (Page 22)

S T O R E Y E S
F c t . 3. 0 0
I N S T A L L.
F c t . 1. 5
C U R R E N T I
F U N C T. I
F c t . 1. 5
C U R R E N T I
F c t . 1. 4
D I S P L A Y
F c t . 1. 0 0
O P E R AT I O N
Installation and operating instructions IFC 020 4/3
4.3 Function of keys
The cursor (flashing part of display) has a grey background in the following descriptions.
To start operator control
PLEASE NOTE: When “YES” is set under Fct. 3.04 ENTRY CODE, “CodE 1 - - - - - - - - -”
appears in the display after pressing the → key.
The 9-keystroke Entry Code 1 must now be entered: → → → ↵ ↵ ↵ ↑ ↑ ↑
(each keystroke acknowledged by “
*
”).
To terminate operator control
Press key ↵ repeatedly until one of the following menus
Fct. 1.00 OPERATION, Fct. 2.00 TEST or Fct. 3.00 INSTALL. is displayed.
↑
Increase number
To select a function
Decrease number
↓
→
Switch to function
To select a sub function
Return to function
↵
Measuring mode
1 3 . 5 7 1
m 3 / h r
→
Operator control mode
↵
Press key ↵
Store new parameters: acknowledge by
pressing key ↵ . Measuring mode continued
with the new parameters.
New parameters not to be stored:
press key ↑ to display „STORE.NO“.
Measuring mode continued with the „old“
parameters after pressing key ↵ .