KROHNE OPTIBAR DP 7060 C EN - Manual (Page 7)

SAFETY INSTRUCTIONS
1
7
OPTIBAR DP 7060 C
www.krohne.com 04/2014 - 4003292001 - MA OPTIBAR DP 7060 C R01 en
1.2 Technical limits
The device was constructed solely for use within the technical limits indicated on the nameplate
and in the technical data. Applications outside of these limits are not permitted and could lead to
significant risk of accident. For this reason, observe the following limits:
• Do not exceed the maximum working pressure (MWP).
• Do not exceed the indicated permissible operating temperature range.
• The permissible ambient temperatures given may not be exceeded or undershot.
• Observe the ingress protection of the housing during use.
1.3 Measured products
The device is designed to measure the pressure of vaporous, gaseous and liquid media. Prior to
using any corrosive or abrasive products, the operator must check the resistance of all materials
which are in contact with the product.
1.4 Certification
CE marking
The device fulfils the statutory requirements of the following EC directives:
• EMC Directive 2004/108/EC
• EMC specification acc. to EN 61326/A1
The manufacturer certifies successful testing of the product by applying the CE marking.
Pressure equipment directive 97/23/EC Pressure equipment directive 97/23/EC Pressure equipment directive 97/23/EC Pressure equipment directive 97/23/EC
Devices with a permissible pressure PS ≤ 200 bar (20 MPa) / 2900 psi comply with Article 3
Section (3) and are not subject to a conformity assessment. These devices were designed and
manufactured in accordance with sound engineering practice (SEP).
The CE marking on the device does not apply to the Pressure Equipment Directive.
.book Page 7 Friday, May 2, 2014 10:25 AM