KROHNE OPTIBAR DP 7060 C EN - Manual (Page 17)

INSTALLATION
3
17
OPTIBAR DP 7060 C
www.krohne.com 04/2014 - 4003292001 - MA OPTIBAR DP 7060 C R01 en
3.4 Storage
• Store the device in a dry and dust-free location.
• Avoid lasting direct exposure to the sun.
• Store the device in the original packaging supplied.
• Do not expose to aggressive media.
• Avoid mechanical shocks.
• Storage temperature of -40 to +80°C / -40 to +176°F.
• Relative air humidity of 20 to 85%.
3.5 Transport
• Use original packaging for transport and ensure that the packaging does not get crushed or
damaged by sharp objects or other boxes.
• Do not throw or drop the device.
• Avoid temperatures below -40°C / -40°F and above +80°C / +176°F.
• When transporting by ship, use seaworthy outer packing.
3.6 Installation specifications
The accuracy of the measurement is only guaranteed if the transmitter and accompanying
impulse line(s), if any, have been correctly installed. In addition, extreme ambient conditions
including large fluctuations in temperature, vibrations and shocks should be kept as far away as
possible from the measuring equipment.
3.7 Mounting
CAUTION!
Observe the storage information found on the packaging. Labels on the original packaging must
always remain legible and may not be damaged.
INFORMATION!
Observe the relevant directives, ordinances, standards and accident prevention regulations (e.g.
VDE/VDI 3512, DIN 19210, VBG, Elex V, etc.).
CAUTION!
•
Prior to installing the pressure transmitter, it is essential to verify whether the version of the
device on hand completely fulfils the technical and safety requirements of the measuring
point. This applies in particular to the measuring range, overpressure resistance,
temperature, explosion protection and operating voltage.
• Check the materials used for the wetted parts (e.g. gasket, process connection, separating
diaphragm etc.) for suitability as regards process compatibility.
.book Page 17 Friday, May 2, 2014 10:25 AM