KROHNE OPTIBAR DP 7060 C EN - Manual (Page 6)

1
SAFETY INSTRUCTIONS
6
OPTIBAR DP 7060 C
www.krohne.com 04/2014 - 4003292001 - MA OPTIBAR DP 7060 C R01 en
Safety instructions
1.1 Intended use
The OPTIBAR DP 7060 C is a differential pressure transmitter suitable for measuring flow, level,
differential pressure, density and interface of gases, vapours and liquids. The available
measurement ranges and the respective permissible overloads are indicated on the nameplate.
To observe the intended use, adhere to the following points:
• Observe the instructions in this document.
• Comply with the technical specifications (for further information refer to
Technical data on
page 63).
• Only suitably qualified personnel may install and operate the device.
• Observe the generally accepted standards of good practice.
DANGER!
For devices used in hazardous areas, additional safety instructions apply.
CAUTION!
Responsibility for the use of the measuring devices with regard to suitability, intended use and
corrosion resistance of the used materials against the measured fluid lies solely with the
operator.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose.
CAUTION!
•
Any modification to the device, including drilling, sawing, trimming, welding and soldering of
parts, or partially painting over or coating, is prohibited.
• Neither is it permitted to use the device as a climbing aid e.g. for installation purposes, as a
holder for cables, pipes or other loads.
• The mounting or installation of parts is only permitted as described in this document, or
insofar as it has been authorised by the manufacturer or a certified service partner.
.book Page 6 Friday, May 2, 2014 10:25 AM