KROHNE OPTIBAR DP 7060 C EN - Manual (Page 49)

START-UP
5
49
OPTIBAR DP 7060 C
www.krohne.com 04/2014 - 4003292001 - MA OPTIBAR DP 7060 C R01 en
5.4.3 Diagnosis
Device status Status signals Check function, Out of Specification, Maintenance required, Failure
Peak value The respective minimum and maximum pressure values are stored in the device. Under "Peak
values", these values can be viewed or reset. In addition to the pressure, the minimum and maximum
values of the sensor cell and the electronics temperature is stored. These can be viewed or reset
here.
Peak value
"Pressure"
Reset peak value
Peak value
"Differential pressure"
Reset peak value
Peak value
"Static pressure"
Reset peak value
Peak value
"Meas. cell temp."
Reset peak value
Peak value
"Electronics temperature"
Reset peak value
Simulation In menu item "Simulation", measured values can be simulated via the current output. These are
issued as both analogue and digital (via HART
® ). The simulation is automatically cancelled 60
minutes after the last key stroke.
For applications
"Differential pressure"
Differential pressure, Static pressure, Percent, Current output,
Linear percent, Meas. cell temp. and Electronics temperature
For applications
"Flow"
Flow, Differential pressure, Static pressure, Pressure, Scaled,
Current output, Linear percent, Meas. cell temp. and Electronics
temperature
For applications
"Level"
Filling height or Pressure (Adjustment units), Static pressure,
Percent, Current output, Linear percent, Meas. cell temp. and
Electronics temperature
For applications
"Interface"
Interface height, Differential pressure, Percent, Current output,
Linear percent, Meas. cell temp. and Electronics temperature
For applications
"Density"
Density, Differential pressure, Percent, Current output, Linear
percent, Meas. cell temp. and Electronics temperature
.book Page 49 Friday, May 2, 2014 10:25 AM