B.7 calibrate:subnetmask command, B.8 calibrate:subnetmask? query, B.9 calibrate:gatewayadd command – KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.22 through 3.41 User Manual

Page 63: B.10 calibrate:gatewayaddress? query, B.11 calibrate:gpib command, B.12 calibrate:gpib? query, B.13 calibrate:dnsadd command, B.14 calibrate:dnsadd? query, Calibrate:subnetm, Calibrate:g

SERIES EL 062011

B-3

B.7

CALibrate:SUBNetmask COMMAND

CAL:SUBN

Syntax:

Short Form: CAL:SUBN
Long Form: CALibrate:SUBNetmask
Where: = numbers from 0 to 255 comprising the Subnet Mask

Description: Sets the Subnet Mask to be used during LAN communication.

B.8

CALibrate:SUBNetmask? QUERY

CAL:SUBN?

Syntax:

Short Form: CAL:SUBN?

Long Form: CALibrate:SUBNetmask?

Returns: = numbers from 0 to 255 comprising the Subnet Mask

Description: Returns the Subnet Mask used during LAN communication.

B.9

CALibrate:GATEwayadd COMMAND

CAL:GATE

Syntax:

Short Form: CAL:GATE
Long Form: CALibrate:GATEwayadd
Where: = numbers from 0 to 255 comprising the Gateway Address.

Description: Sets the Gateway Address to be used during LAN communication.

B.10 CALibrate:GATEwayaddress? QUERY

CAL:GATE?

Syntax:

Short Form: CAL:GATE?

Long Form: CALibrate:GATEwayaddress?

Returns: = numbers from 0 to 255 comprising the Gateway Address

Description: Returns the Gateway Address used during LAN communication.

B.11 CALibrate:GPIB COMMAND

CAL:GPIB

Syntax:

Short Form: CAL:GPIB
Long Form: CALibrate:GPIB
Where: = numbers from 1 to 30 comprising the GPIB Address. Factory default GPIB address
is 10.

Description: Sets the GPIB Address to be used during communication over the GPIB interface. After setting

the address, the EL Load must be power cycled (turned off, then on) in order for the new GPIB
address to take effect. Command is not valid from the GPIB interface.

B.12 CALibrate:GPIB? QUERY

CAL:GPIB?

Syntax:

Short Form: CAL:GPIB?

Long Form: CALibrate:GPIB?

Returns: = number from 1 to 30 comprising the GPIB Address

Description: Returns the GPIB Address used during communication over the GPIB interface. Command is

not valid from the GPIB interface.

B.13 CALibrate:DNSadd COMMAND

CAL:DNS

Syntax:

Short Form: CAL:DNS
Long Form: CALibrate:DNSadd
Where: = numbers from 0 to 255 comprising the DNS Address.

Description: Sets the Gateway Address to be used during LAN communication.

B.14 CALibrate:DNSadd? QUERY

CAL:DNS?

Syntax:

Short Form: CAL:DNS?

Long Form: CALibrate:DNSadd?

Returns: = numbers from 0 to 255 comprising the DNS Address

Description: Returns the DNS Address used during LAN communication.