KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.22 through 3.41 - Manual (Page 62)

B-2
SERIES EL 062011
B.2 NUMERICAL VALUES AND DATA CONVENTIONS
The following conventions are used throughout this Appendix.
< > Items in these brackets are parameter abbreviations. Parameters may be numbers or text
Simple numbers (without a decimal point) from 0 - 255. Examples: 156, 0 or 1
Numeric Values with or without a decimal point. Examples: 0.0156, 15.6, 156 or 1.56E+3 (scientific
notation: digits with decimal point and exponent)
Text data. For example, operating modes: CURRent, VOLTage, POWer, RESistance, CONDuc-
tance, SHORt
Boolean Data. Examples: 0, 1, OFF or ON. NOTE: If a command expecting a boolean argument is
sent with no argument, the argument is assumed to be 0 (e.g., INPut and INPut 0 are identical).
[ ] Optional keywords are shown in square brackets. For example [SOURce:]INPut:[STATe]
means SOURce and STATe: may be omitted thus the command is reduced to INP .
B.3 CALibrate:IPADdress COMMAND
CAL:IPAD
Syntax: Short Form: CAL:IPAD
Long Form: CALibrate:IPADdress
Where: = numbers from 0 to 255 comprising the IP Address
Description: Sets the IP address to be used during LAN communication.
B.4 CALibrate:IPADdress? QUERY
CAL:IPAD?
Syntax: Short Form: CAL:IPAD? Long Form: CALibrate:IPADdress?
Returns: = numbers from 0 to 255 comprising the IP Address
Description: Returns the IP Address used during LAN communication.
B.5 CALibrate:IPMODE COMMAND
CAL:IPMODE
Syntax: Short Form: CAL:IPMODE [STAT | DCHP | AUTO | FUL]
Long Form: CALibrate:IPMODE [STATic | DCHP | AUTOmatic | FULl]
Description: Determines method used to obtain IP address for LAN communication. CAL:IPMODE:STAT
(default) configures the LAN port to use a static (fixed) IP address entered from the front panel.
CAL:IPMODE DCHP configures the LAN port for the standard DCHP hub required interface: uses IP
address in the 192.168.x.x range compatible with most default hub configurations.
CAL:IPMODE AUTO configures the LAN port to automatically try addresses in 169.254.001.000
through 169.254.254.255 address range to find an IP address automatically.; CAL:IPMODE FUL con-
figures the LAN port to first try DCHP protocol and if the DCHP server is not found, tries AUTO proto-
col to find IP address.
B.6 CALibrate:IPMODE? QUERY
CAL:IPMODE?
Syntax: Short Form: CAL:IPMODE? Long Form: CALibrate:IPMODE?
Returns: [STATic | DCHP | AUTOmatic | FULl]
Description: Returns IP Mode (method of finding the IP Address used during LAN communication); see
PAR. B.5.