KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.22 through 3.41 - Manual (Page 16)

1-6
SERIES EL 062011
1.7 EQUIPMENT SUPPLIED
Equipment supplied with the unit is listed in Table 1-3.
TABLE 1-3. MODE CHARACTERISTICS
MODE Linearity Vs. Programming Command Regulation (1)
Constant Current ±0.25% ±0.25%
Constant Power ±2% ±1%
Constant Voltage ±0.25% (±1% for 50V models) ±0.25%
Constant Resistance ±1% ±1%
Constant Conductance ±1% ±1%
(1) Regulation specified after 15 minutes of operation at set power level
TABLE 1-4. EQUIPMENT SUPPLIED
ITEM PART NUMBER QUANTITY
Source Power cable 118-1234
(Unicable 3850-761-BB/G)
1
Series EL Quick Start Guide * 228-1687 1
EL Series (except Dual models) ±LOAD terminal hardware
Screw, Cap, Hex, Silicon bronze, 3/8-16 (coarse thread) x 1 in.
Nut, Hex, silicon bronze, 3/8-16
Washer, split, silicon bronze, 3/8
Washer, flat, silicon bronze, 3/8
EL Series Dual models ±LOAD terminal hardware
Screw, Cap, Hex, Silicon bronze, 5/16-18 (coarse thread) x 1 in.
Nut, Hex, silicon bronze, 5/16-18 (Dual load only)
Washer, split, silicon bronze, 5/16 (Dual load only)
Washer, flat, silicon bronze, 5/16 (Dual load only)
101-0507
102-0182
103-0196
103-0197
101-0065
102-0011
103-0005
103-0212
2
2
2
4
4
4
4
8
Ground stud hardware
Wingnut, 1/4-20, 18-8 stainless-steel
Washer, Flat, 1/4 in., 18-8 stainless-steel
Washer, split, 1/4 in., 18-8 stainless-steel
Nut, 1/4-20, 18-8 stainless-steel 102-0190
103-0201
103-0204
102-0188 1
2
1
1
Chassis slide mounting screw, 10-32 x 5/16 in. (replaces screws pro-
vided with chassis slides which must be discarded) 101-0299 7
Fuse 3A, SB 141-0129
(Littelfuse 0313003.HXP)
1
* Series EL USB Driver Manual and Series EL Operator Manual are available for free download from the Kepco website
at www.kepcopower.com/support/opmanls.htm#e
Series EL Drivers are available for free download at www.kepcopower.com/drivers/drivers-dl3.htm#el