Jenway Genova Nano German - Manual (Page 6)

6.4 SAMPLE MEASUREMENT 28
6.4.1 Measuring a Sample After Calibrating to a Standard 28
6.4.2 Measuring a Sample After Calibrating to a Factor 29
SECTION 7 – Spectrum 30
7.1 MODE SPECIFIC PARAMETERS 30
7.2 METHOD SETUP 30
7.2.1 Scan Settings 31
7.2.1.1 Selecting Absorbance or % Transmittance 31
7.2.1.2 Setting Start and End Wavelengths 31
7.2.1.3 Setting the Scan Interval 32
7.2.1.4 Y-Axis Scaling 32
7.3 CALIBRATION 33
7.4 SAMPLE MEASUREMENT 33
7.5 DATA ANALYSIS 34
7.5.1 Peaks and Valleys Threshold 34
7.5.2 Peaks and Valleys Table 34
7.5.3 Spectral Points Analysis 35
SECTION 8 – Quantitation 37
8.1 MODE SPECIFIC PARAMETERS 37
8.2 METHOD SETUP 37
8.2.1 Quantitation Settings 38
8.2.1.1 Selecting Absorbance or % Transmittance 38
8.2.1.2 Selecting a Wavelength 38
8.2.1.3 Selecting Concentration Units 38
8.2.1.4 Changing the Resolution 38
8.2.1.5 Selecting the Number of Replicate Standard Measurements 39
8.2.1.6 Selecting Automatic or Manual Replicate Measurements 39
8.2.1.7 Selecting Number of Standards 39
8.2.2 Quantitation Table 39
8.2.2.1 Editing Standard Data 39
8.2.2.2 Creating a New Standard Curve 40
8.2.3 Standard Curve 41
8.3 CALIBRATION 42
8.4 SAMPLE MEASUREMENT 42
8.5 DATA ANALYSIS 43
SECTION 9 – Kinetics 44
9.1 MODE SPECIFIC PARAMETERS 44
9.2 METHOD SET UP 44
9.2.1 Kinetics Settings 45
9.2.1.1 Y-Axis Scaling 45
9.2.1.2 Setting Lag Time or Start on Level 46
9.2.1.3 Selecting Absorbance or % Transmittance 46
9.2.1.4 Changing the Resolution 46
9.2.1.5 Selecting Concentration Units 47
9.2.1.6 Using a Standard 47
9.2.1.7 Using a Factor 47
9.2.1.8 Selecting a Wavelength 48
9.2.1.9 Setting the Kinetics Measurement Time 48
9.3 CALIBRATION 48
9.4 SAMPLE MEASUREMENT 48
9.5 DATA ANALYSIS 49
4