GW Instek GBS-1000 Series User Manual User Manual
Digital storage oscilloscope
Table of contents
Document Outline
- SAFETY INSTRUCTIONS
- GETTING STARTED
- QUICK REFERENCE
- Menu Tree / Operation Shortcuts
- Convention
- Acquire key
- Auto Set key
- Auto test/Stop key
- CH1 ~ 4 key
- Cursor key
- Display key
- Hardcopy key
- Help key
- Horizontal menu key
- Math key (1/2)
- Math key (2/2)
- Measure key (1/2)
- Measure key (2/2)
- Program key (1/2)
- Program key (2/2)
- Run/Stop key
- Save/Recall key (1/10)
- Save/Recall key (2/10)
- Save/Recall key (3/10)
- Save/Recall key (4/10)
- Save/Recall key (5/10)
- Save/Recall key (6/10)
- Save/Recall key (7/10)
- Save/Recall key (8/10)
- Save/Recall key (9/10)
- Save/Recall key (10/10)
- Trigger key (1/5)
- Trigger key (2/5)
- Trigger key (3/5)
- Trigger key (4/5)
- Trigger key (5/5)
- Utility key (1/11)
- Utility key (2/11)
- Utility key (3/11)
- Utility key (4/11)
- Utility key (5/11)
- Utility key (6/11)
- Utility key (7/11)
- Utility key (8/11)
- Utility key (9/11)
- Utility key (10/11)
- Utility key (11/11)
- Default Settings
- Built-in Help
- Menu Tree / Operation Shortcuts
- MEASUREMENT
- CONFIGURATION
- SAVE/RECALL
- PRINT OUT
- REMOTE CONTROL CONFIG
- MAINTENANCE
- FAQ
- I pressed the Power (On/Standby) key on the front panel but nothing happens.
- I connected the signal but it does not appear on the display.
- I want to remove the (Measurement result / FFT result / Help contents) from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Auto Set does not catch the signal well.
- I want to clean up the cluttered panel settings.
- The display image printout is too dark on the background.
- The date and time settings are not correct.
- USB does not work.
- The accuracy does not match the specification.
- APPENDIX
- INDEX