GW Instek GBS-1000 Series User Manual - Manual (Page 91)

MEASUREMENT
91
4. Press F3 (From/To) to select
the From: side. Use the
Variable knob to select the
program start step: 1 ~ 20.
The “S” mark appears in the
selected step.
From: 1
To: 4
F 3
5. Press F3 (From/To) to select
the To: side. Use the
Variable knob to select the
program end step: 1 ~ 20.
Note that the To: step must
be larger or equal to the
From: step. The “E” mark
appears in the selected step.
From: 1
To: 4
F 3
6. Press F5 (Start). The display
changes into program
running mode and starts
executing the first step.
Start F 5
7. The message “Press
Run/Stop key to continue”
on the bottom of the display
shows that the user has to
activate the next step
manually. Press the
Run/Stop key to move to
the next step.
Run/Stop
8. To stop the program
manually, press the Auto
test/Stop key. When all
steps are completed, the
program stops running.
Auto test/Stop