GW Instek GBS-1000 Series User Manual - Manual (Page 23)

GETTING STARTED
23
Power up
Step 1. Connect the power cord to
the rear panel socket.
2. Turn On the main power
switch. : On, : Off.
3. The ON/STBY indicator
on the front panel turns
red.
4. Press the ON/STBY key.
The indicator turns green
and the display becomes
active in 6 ~ 8 seconds.
Note GBS-1000 recovers the state from right before the
power was last turned off. The default setting can
be recovered by pressing the Save/Recall key → F1
(Default Setup). For details, see page155.