GW Instek GBS-1000 Series User Manual - Manual (Page 53)

MEASUREMENT
53
Basic Measurement
This section describes the basic operations required in capturing
and viewing the input signal. For detailed operation, see the
following chapters.
 Measurements → from page51
 Configurations → from page92
Channel activation
Activate channel To activate an input channel,
press the Channel key. The
LED turns On and the input
signal waveform appears on
the display.
De-activate
channel To disable the channel, press
the Channel key again. If the
display menu is different from
the Channel menu, press twice
(the first press shows the
Channel menu).
Default setup When the default setup is recalled (Save/Recall
key → F1), Channel 1 automatically turns On.
Channel 2, 3, and 4 turn Off.
Auto Set Auto Set (page54) does NOT automatically activate
the channels to which input signals are connected.