GW Instek GBS-1000 Series User Manual - Manual (Page 86)

GBS-1000 Series User Manual
86
5. Press F4 (Go-NoGo). The
Go-NoGo test starts running
and stops according to the
continue/stop condition
(page80). To stop the test
manually, Press F4 again.
Go-NoGo
On
F 4
6. The test results appear in
the F5 menu. The
denominator (lower side)
shows the number of
completed tests. The
numerator (upper side)
shows the number of failed
tests (NoGo).
Pressing F5 will also clear
the test results from the
icon.
Ratio:
3
6
F 5
7. The Go/NoGo terminal
(open collector) on the rear
panel sends out a 5Vpp,
10us pulse signal to an
external device every time
the NoGo condition is met.