GW Instek GDS-1000-U Series Programming Manual - Manual (Page 66)

GDS-1000-U Programming Manual
66
:TRIGger:REJect
Set
Query
Description Selects the trigger rejection filter.
Same as: Trigger key → F4 → F3
Syntax < Long > < Short >
:trigger:reject
:trigger:reject? :trig:rej
:trig:rej?
Parameter Rejection filter
0 off
1 LF
2 HF
Note Before using this command, select the edge or
pulse trigger. See the example below.
Example :trigger:type 0
:trigger:reject 1 Selects the edge trigger
and LF rejection filter
:TRIGger:SLOP
Set
Query
Description Selects the trigger slope.
Same as: Trigger key → F4 → F1
Syntax < Long > < Short >
:trigger:slop
:trigger:slop? :trig:slop
:trig:slop?
Parameter Trigger slope
0 + (positive)
1 – (negative)
Note Before using this command, select the edge or
pulse trigger. See the example below.