GW Instek GDS-1000-U Series Programming Manual - Manual (Page 14)

GDS-1000-U Programming Manual
14
Acquisition Command
:ACQuire:AVERage ...................................................... 14
:ACQuire:MODe .......................................................... 14
:ACQuire:MEMory................................................. 15
:ACQuire:AVERage
Set
Query
Description Selects or returns the average number of waveform
acquisitions that are used in the average
acquisition mode.
Same as: Acquire key → F2
Syntax < Long > < Short >
:acquire:average
:acquire:average? :acq:aver
:acq:aver?
Parameter Average No. Average No.
1 2 5 32
2 4 6 64
3 8 7 128
4 16 8 256
Note Before using this command, select the average
acquisition mode. See the example below.
Example :acquire:mode 2
:acquire:average 2 Selects the average
acquisition mode, and
select the average
number 4
:ACQuire:MODe
Set
Query
Description Selects or returns the acquisition mode.
Same as: Acquire key → F1 ~ F3