GW Instek GDS-1000-U Series Programming Manual - Manual (Page 32)

GDS-1000-U Programming Manual
32
:MEASure:FREQuency
Query
Description Returns the frequency value.
Same as: Measure key → F1~F5 → F3 (Frequency)
Syntax < Long > < Short >
:measure:frequency? :meas:freq?
Returns
Note Before using this command, select the
measurement channel. See the example below.
Example :measure:source 1
:measure:frequency? Selects Channel 1, and
then measures the
frequency.
:MEASure:NWIDth
Query
Description Returns the first negative pulse width timing.
Same as: Measure key → F1~F5 → F3 (–Width)
Syntax < Long > < Short >
:measure:nwidth? :meas:nwid?
Returns
Note Before using this command, select the
measurement channel. See the example below.
Example :measure:source 1
:measure:nwidth? Selects Channel 1, and
then measures the
negative pulse width.
:MEASure:PDUTy
Query
Description Returns the positive duty cycle ratio.
Same as: Measure key → F1~F5 → F3 (DutyCycle)
Syntax < Long > < Short >