GW Instek GDS-1000-U Series Programming Manual - Manual (Page 5)

INTERFACE OVERVIEW
5
Configuring the USB Interface
USB connection PC end Type A, host
GDS-1000-U end Type B, slave
Speed 1.1/2.0 (full speed)
Procedure 1. Connect the USB cable to
the USB slave port on the
GDS-1000-U.
2. When the PC asks for the USB driver, select
dso_cdc_1000.inf which is downloadable from
the GW website, www.gwinstek.com.tw, GDS-
1000-U product corner.
3. On the PC, activate a terminal application such
as MTTTY (Multi-Threaded TTY). To check the
COM port No., see the Device Manager in the
PC. For WindowsXP, select Control panel →
System → Hardware tab.
4. Run this query command via the terminal
application.
*idn?
This command should return the manufacturer,
model number, serial number, and firmware
version in the following format.
GW, GDS-1052-U, 000000001, V1.00
5. Configuring the command interface is
completed. Refer to the programming manual
for the remote commands and other details.