GW Instek GDS-1000-U Series Programming Manual - Manual (Page 13)

COMMAND DETAILS
13
*RST
Set
Description Resets the GDS-1000-U (recalls the default panel
settings).
Same as: Save/Recall key → F1
Syntax *rst
:SYSTem:ERRor
Query
Description Returns the oscilloscope system error messages, if
there are any.
Syntax < Long > < Short >
:system:error? :syst:err?
Parameter ID Contents ID Contents
-100 command error -102 syntax error
-220 parameter error -221 settings conflict
-222 data out of range -223 too much data
-224 illegal parameter -232 invalid format
Example :system:error?
-102 Indicates that the
command syntax is
wrong
:SYSTem:VERSion
Query
Description Returns the oscilloscope firmware version.
Same as: Utility key → F4 (only the firmware
version)
Syntax < Long > < Short >
:system:version? :syst:vers?
Note For retrieving all system information including the
firmware version, use the *idn? command.