Fire-Lite MRP-2002C Agent Release Control Panel - Manual (Page 106)

106 MRP-2002 Series Instruction Manual — P/N 53049:E2 3/7/2013
Operating Instructions Read Status
Pressing 1 allows the user to print the History file which will detail all of the system activities since
the file was last cleared from memory.
Pressing 2 allows the user to print the Walktest log which will detail all of the system activations
during walktest since the log was last cleared. Refer to “Walktest” on page 85 for additional infor-
mation on the display.
Pressing 3 will exit the Print operation.
4.15.11 ANN-BUS
Pressing 2 while viewing Read Status Screen #4 will display the settings for the ANN-BUS options
as shown in the following screens:
ANN-BUS Screen #1 indicates whether the ANN-BUS is enabled (Yes/No).
Pressing 1 while viewing ANN-BUS Screen #1 will display BUS Module addresses 1-8 and the
devices, if any, located at those addresses.
Pressing 2 while viewing ANN-BUS Screen #1 will display the programmed options for the
ANN-S/PG Module devices connected to the ANN-BUS.
Pressing 1 while viewing ANN-BUS Screen #2 will display the programmed options for the
ANN-80 LCD annunciators connected to the ANN-BUS.
Pressing 2 while viewing ANN-BUS Screen #2 will display the programmed options for the
ANN-RLY devices connected to the ANN-BUS.
ANN-BUS
BUS ENABLED NO
1=BUS MODULES
2=ANN-S/PG OPTIONS
ANN-BUS
1=ANN-80 OPTION
2=ANN-RLY OPTIONS
ANN-BUS Screen #1
ANN-BUS Screen #2