Fire-Lite MRP-2001C PRE-ACTION/DELUGE CONTROL PANEL - Manual (Page 56)

56 MRP-2001 Series Manual — P/N 53040:D 12/15/2010
Programming Master Programming Level
Pressing 2 while viewing the Adjective/Noun Screen will cause the following screen(s) to be
displayed. Note that the keyboard down arrow key must be pressed to see all the Noun screens.
Press the number corresponding to the noun that is to be used as a descriptor for the location of the
detector currently being programmed. When a noun has been selected, it will appear at the top of
the display as indicated by the asterisks.
Description
The Description selection allows the programmer to enter additional information about the detector
currently being programmed. This information will be displayed as part of the device label on the
display. Pressing 2 while viewing Edit Input Zone Screen #3 will cause the following screen to be
displayed:
A flashing cursor will appear at the first asterisk to the left. The programmer can enter additional
descriptive information about the device being programmed. This information will appear on the
display along with the standard device label information.
**********************
1=BASEMENT
2=BOILER RM
3=CLASSROOM
Noun Screen #1
**********************
1=COMPUTER RM
2=CONTROL RM
3=DATA ROOM
Noun Screen #3
**********************
1=DOCUMENT RM
2=ELECTRIC RM
3=GARAGE
Noun Screen #5
**********************
1=HVAC RM
2=ISLAND
3=KITCHEN
Noun Screen #2
**********************
1=ROOM
2=STOREROOM
3=TELCO ROOM
Noun Screen #4
**********************
1=UPS ROOM
2=VAULT
Noun Screen #6
INPUT ZONE #
1=ADJECTIVE/NOUN
2=DESCRIPTION
Edit Input Zone Screen #3
ZONE # DESCRIPTION
PRESS ENTER IF DONE
********************
Adjective/Noun Screen