Fire-Lite ECC-50/100E Emergency Command Center - Manual (Page 73)

Emergency Command Center Manual —
P/N LS10001-000FL-E:A 4/10/2013 73
Recording Custom Messages
Programming
Press the PTT button on the microphone and speak the message. Release the PTT button to save
the message. The yellow zone 5 LED will stay lit while recording. The green LED for zone button
5 will light after the recording is complete.
Enter programming mode again and deselect Message Record Mode.
3.4.4 Erasing a User Message
Messages stored in message slots 1-14 can be erased.
1. Enter programming mode at the main control board.
2. Enable Recording Mode in the system’s message recording programming section. Refer to
Section 3.4.1 on page 70. The display board will then light the green zone 1-14 LEDs for all
message slots that contain messages.
3. Press zone button 24 on the display board, then zone button 1-14 for the slot to be erased. The
associated green zone LED will stay lit until complete.
4. Enter programming mode and deselect Message Record Mode.
3.4.5 Audio Programming Utility Software
The Audio Programming Utility (APU) software is used to download recorded messages (in .ske
format stored on a computer’s hard drive) to the various message slots of the ECC-50/100. Mes-
sages can be uploaded, stored, and used again in similar installations.
Make sure the system is in Normal Standby mode.
To write a message to the panel follow steps 1 through 5. To read a message from the panel follow
steps 1 through 4. To move a message from one message slot location to another follow step .
Press zone button
17 to record
Press zone button 5
to select message
slot 5
Figure 3.1 Microphone Recording Example
e
c
c
k
y
p
d
.w
m
f