Fire-Lite ECC-50/100E Emergency Command Center - Manual (Page 70)

70
Emergency Command Center Manual —
P/N LS10001-000FL-E:A 4/10/2013
Programming
Recording Custom Messages
in this box. Note that the Date and Time in the heading of the print screen correspond to those of
the panel and not the computer. The Unit ID reflects the name of the panel assigned in the General
Options page. Refer to “General Options” on page 60.
3.4 Recording Custom Messages
The system has 14 recordable message slots. Messages can be recorded from the microphone,
external audio input, or by using the Audio Programming Utility (APU) software. Each message
can be up to one minute in duration.
3.4.1 Message Record Mode
Enable Recording Mode in the system’s message recording programming section. Refer to
Section 3.2.1 on page 66.
While in Local Record mode, zone buttons 1-14 are used to reference message slots 1-14. The
associated green zone LED will indicate whether a message is currently programmed in the corre-
sponding slot. The associated yellow zone LED will indicate a recording in progress. The zone
buttons 1-14 will be used to play back a recorded message or to reference a message slot that needs
to be recorded or erased.
Zone buttons 17, 19, and 24 are used to control the recording/erasing process.
When in Local Record mode, the display board’s LEDs will function as follows:
3.4.2 External Audio Input
The external audio input allows customized, pre-recorded messages to be loaded into a message
slot.
1. Wire a speaker cable with 1/8” mini plug (Radio Shack p/n 42-2454) to EXT Audio GND and
IN terminals on the display board.
Button Function
Zone
Button 17 Select message slot
Zone
Button 19 Start and stop recording
from External Audio
Input terminals
Zone
Button 24 Erase selected message
slot
LED Active LED Status Meaning
Zone Button 1-14 Green LED On Message is currently programmed in this slot.
Zone Button 1-14 Yellow LED On LED will turn on until recording is complete or
the 1 minute slot is full.
Zone Button 1-14 Green LEDs Off Slot is available to record.
zone
buttons
1-14
zone
buttons
17, 19, 24
The associated
yellow LEDs for
these buttons turn
on to indicate
being pressed.