Rebooting the camera – Avigilon ACC Enterprise Client Version 4.12 User Manual
Page 77
Setup
69
1. Right-click the camera in the System Explorer then select Setup to open the camera Setup dialog
box.
See
2. Click General. The General dialog box appears.
3. In the PTZ area, select the Enable PTZ check box.
Note:
If the following options are not displayed, the camera only has a motorized zoom
and focus lens and cannot perform full PTZ. Selecting the Enable PTZ Controls check
box will allow users to control the zoom and focus through the PTZ Controls pane.
4. In the Protocol drop down list, select the appropriate PTZ protocol. The available protocols
include:
o
American Dynamics Sensormatic
o
AXSYS
o
AXSYS DCU
o
Ernitec ERNA
o
Honeywell Diamond
o
Kalatel ASCII
o
Pelco D
o
Pelco P
o
TEB Ligne
o
Vicon extended
o
Vicon normal
o
Videotec Legacy
o
Videotec MACRO
5. Enter the Dip Switch Address, Baud Rate and Parity for the PTZ device.
6. Click OK.
Rebooting the Camera
You can restart all Avigilon cameras through the camera's General dialog box. This feature is not
available for third party cameras.
1. Right-click the camera in the System Explorer then select Setup to open the camera Setup dialog
box.
See