Flow - utilities menu - meter selection 7.3, Multi-parameter transmitter user’s manual – Aquametrix SHARK TX / TXP Transmitters User Manual User Manual

Page 69

MULTI-PARAMETER TRANSMITTER USER’S MANUAL

Flow - Utilities Menu - Meter Selection 7.3

Flow - Utilities Menu - Meter Selection 7.3

Page 67

DOWN

If you do not wish to initialize to this
type of meter after all, then press
key to return back to the Meter
Selection menu

Then press
The controller will initialize itself for a
specific meter

If you do wish to initialize to this
type of meter, press the
key to highlight the Y character

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Press the key to Exit and
return to the Utilities menu

RUN MODE

Press the key to initialize the
controller as a Flow meter

Press the key to initialize the
controller as a Conductivity meter

The Meter Selection menu is used to select the meter type that the
controller is configured for, either pH, ORP, Conductivity or FLow.
Once selected, the controller will initialize itself for the selected meter's
functionality and move to run mode.

Press the key to initialize the
controller as an ORP meter

Press the key to initialize the
controller as a pH meter.

INITIALIZE? Y N

FLOW

E XIT

MANUAL TEST MODE

TOTAL 0

UTILITIES

CALIBRATION

METER SELECTION

C ONDUCTIVITY
FLOW

EXIT

F LOW

CONDUCTIVITY

O RP

CONDUCTIVITY

FLOW

ORP

P H

ORP

To reset the controller back to all
the factory default values, reselect
the current meter type