Conductivity - setup menu - temp. sensor 6.8, Multi-parameter transmitter user’s manual – Aquametrix SHARK TX / TXP Transmitters User Manual User Manual

Page 56

MULTI-PARAMETER TRANSMITTER USER’S MANUAL

Conductivity - Setup Menu - Temp. Sensor 6.8

Conductivity - Setup Menu - Temp. Sensor 6.8

Page 54

DOWN

With "N" selected, pressing the
key will NOT store the selection, but
simply return to the TEMP SENSOR
Selection Menu. This function is useful
if you wish to view the current
selection without making any changes.

RUN MODE

Then press the key to store the
selection and return to the TEMP
SENSOR Selection Menu.

Press the key to accept the
change and move to the store function

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Not stored

Stored

Or press the key to highlight

the Y character.

Press the key once
which will move the cursor
over to the sensor type.

Once the correct Sensor has
been selected press the
key once which will move the
cursor back to the RH side of
the display.

Use the or to select
the sensor type

TEMP SENSOR allows the user to select the
type of temperature sensor used the in the
probe.
The factory default for Conductivity is a 3000

Ω

NTC thermistor. The user can also select a
300

Ω

NTC thermistor or a Pt. 1000 RTD.

TEMP SENSOR

1000uS 25.0C

CALIBRATION

UTILITIES

SETUP

COND RANGE

TEMP UNIT

STORE? Y N

3 00 NTC

TEMP SENSOR

3000 NTC

3 000 NTC

1 000 RTD

3000 NTC

Ω

TEMP SENSOR

Ω

TEMP SENSOR

Ω