Aquametrix SHARK TX / TXP Transmitters User Manual - Manual (Page 11)

MULTI-PARAMETER TRANSMITTER USER’S MANUAL
Section 3 - Electrical Connections and Setup
Section 3 - Electrical Connections and Setup Page 9
3.5 Conductivity Cell (Contacting style) connections and setup
Figure 3.4 Connections for Conductivity Cells
Once connnected, step
through the LCD menus to
select the cell in the order
shown. The TEMP COMP
CURVE setup default is
1.8%/deg C. This is accept-
able for most process appli-
cations. If your process is
significantly different from
this, change the setting in
the TEMP COMP CURVE
menu.
The drawing shows the connections for the Aquametrix Conductivity Cells (Contacting style). The cable
should be run in a conduit seperate from the AC power wires, and via a seperate conduit hole. The cell
cable length should not exceed 300ft. (91 meters).
Dwg# N104-44
CAUTION:
Always disconnect
the loop power
before wiring or
unwiring a sensor